Reduce the fan speed

  1. Disconnect the power cord.
  2. Detach the light from the ceiling.
  3. Disconnect the light cord from the control unit. Set the light aside.
  4. The settings in the following step are for software version 2.2 of the control unit. To check the software version of the control unit, scan the QR code on the side of the control unit.
    Note: Older pods might not have the QR code on the control unit.
  5. Use a flat-head screwdriver to turn the arrow of the SETUP switch at the control unit to the desired position.
    The default position is 0.
    Note: The light switches off after 8 minutes of no activity in each of the settings.
    Note: Reducing the fan speed decreases the rate of air flow inside the pod. Adjusting the fan speed to under 80 % when occupied is not recommended. It is at your own risk to set the fan speed to under 80 % (when occupied).
    Table 1. Version 2.2
    Setting Fan speed (pod occupied) Fan speed (pod unoccupied) Ceiling light
    0 100 % 25 % 80 %
    1 80 % 25 % 80 %
    2 100 % 75 % 80 %
    3 80 % 25 % 100 %
    4 100 % 25 % 90 %
    5 80 % 25 % 90 %
    6 100 % 0 % 80 %
    7 80 % 0 % 80 %
    8 80 % 0 % 100 %
    9 100 % 0 % 100 %
    A 60 % 0 % 80 %
    B 100 % 100 % 100 %
    C 50% 25 % 80 %
    D 60 % 25 % 80 %
    E 70 % 25 % 80 %
    F 100 % 25 % 100 %
  6. Connect the light cord to the LED 1 connector of the control unit.
  7. Reinstall the light.
    Note: Make sure that the cords are not damaged or pinched during the installation.
  8. Connect the power cord.