Reset the fuse

  1. Disconnect the power cord.
  2. Remove 4x30 screws (2 pcs) from the standard table bottom board.
    The wide table bottom board has countersunk M6x25 screws (2 pcs). Use a hex key.
  3. Turn the ON/OFF switch of the power unit in the "I" position.
  4. Fasten the table bottom board with 4x30 screws (2 pcs).
    The wide table bottom board has countersunk M6x25 screws (2 pcs). Use a hex key.
    Note: Make sure that the cords are not between the table boards.
  5. Connect the power cord.
    Note: If the electricity goes out again after connecting the power cord, a faulty device connected to the table power outlet is most likely overloading the circuit and causing the fuse to trip. Disconnect the faulty device from the power outlet.