Adjust the fan speed

Warning: Always unplug the pod from the power outlet before performing any maintenance. To disconnect, remove the plug from the outlet.
  1. Disconnect the power cord.
  2. Remove the 4x30 screws (2 pcs) from the standard table bottom board and open the table bottom board.
    The wide table bottom board has countersunk M6x25 screws (2 pcs). Use a hex key.
  3. The settings in the following step are for software version 2.2 of the control unit. To check the software version of the control unit, scan the QR code on the side of the control unit.
    Note: Older pods might not have the QR code on the control unit.
  4. Use a flat-head screwdriver to turn the arrow on the SETUP switch to the desired position.
    The default position is 0.
    Note: The light switches off after 8 minutes of no activity in each of the settings.
    Note: Reducing the fan speed decreases the rate of air flow inside the pod. Adjusting the fan speed to under 80 % when occupied is not recommended. It is at your own risk to set the fan speed to under 80 % (when occupied).
    Setting Fan speed (pod occupied) Fan speed (pod unoccupied) Ceiling light
    0 100 % 25 % 92 %
    1 80 % 25 % 92 %
    2 100 % 75 % 92 %
    3 80 % 25 % 100 %
    4 100 % 25 % 80 %
    5 80 % 25 % 80 %
    6 100 % 0 % 92 %
    7 80 % 0 % 92 %
    8 80 % 0 % 100 %
    9 100 % 0 % 100 %
    A 60 % 0 % 92 %
    B 100% 100 % 100%
    C 50% 25 % 92 %
    D 60 % 25 % 92 %
    E 70 % 25 % 92 %
    F 100 % 25 % 100 %
  5. Fasten the table bottom board with 4x30 screws (2 pcs).
    The wide table bottom board has countersunk M6x25 screws (2 pcs). Use a hex key.
    Note: Make sure that the cords are not between the table boards.
  6. Connect the power cord.