Install a fire suppression device (sprinkler / cease fire)

DANGER:
Always disconnect the pod from the power outlet before you begin disassembly, maintenance, moving, or any other procedure.
  1. Remove the fan cover.
    Figure 1. * = With optional activated carbon filter
  2. Remove the plastic trims.
  3. Remove the roof body cover.
  4. Remove the precut flap from the roof.
  5. Cut an "X" shape into the acoustic material.
  6. Drill a hole from the middle of the "X" through to the precut flap under the acoustic material.
  7. Use a longer drill bit or anything sharp to punch through from the middle of the hole to the ceiling panel.
  8. Draw the cut line to the ceiling panel. Use the sprinkler cover as a drawing guide.
  9. Cut away the marked area from the ceiling panel. Use a utility knife.
  10. Remove the second precut flap from the roof. Be careful not to tear the ceiling panel fabric around the hole.
  11. Cut away the flap on the roof body cover. Use side cutters.
  12. Install the roof body cover.
  13. Install the plastic trims.
  14. Install the fan cover.
    Figure 2. * = With optional activated carbon filter
Note:
If you are installing a sprinkler system, follow the steps in section 6.1. If you are installing a cease fire unit, follow the steps in section 6.2.