Replace the control panel

  1. Disconnect the power cord.
    If equipped with the optional LAN, also disconnect the LAN cord from the outlet.
    DANGER: Always disconnect the pod from the power outlet before you begin disassembly, maintenance, moving, or any other procedure.
    Figure 1. * = optional LAN
  2. Remove the plastic trims from the techwall.
  3. Remove the wall body cover from the techwall.
  4. Remove the screws from the power unit cover and open the cover.
    Figure 2. * = With the optional wireless charger
  5. Disconnect the CAN cord from the power unit.
    Figure 3. Without the optional wireless charger
    Figure 4. With the optional wireless charger
  6. Disconnect the power outlet cord from the power unit.
    Figure 5. Without the optional wireless charger
    Figure 6. With the optional wireless charger
  7. Remove the screws from the back of the control panel.
    Figure 7. Without the optional wireless charger
    Figure 8. With the optional wireless charger
  8. Remove the old control panel from the techwall.
    Figure 9. * = optional LAN
  9. Connect the CAN cord to the new control panel.
    If the optional LAN cord is included, connect it to the new control panel.
    Figure 10. * = optional LAN cord
  10. Install the new control panel to the techwall.
  11. Connect the power outlet cord to the power unit.
    Figure 11. * = optional LAN cord
  12. Connect the CAN cord to the power unit.
    Figure 12. Without the optional wireless charger (* = optional LAN cord)
    Figure 13. With the optional wireless charger (* = optional LAN cord)
  13. Close the power unit cover and install the screws.
    Note: Make sure that the cords are not pinched or damaged.
    Figure 14. * = With the optional wireless charger
  14. Install the wall body cover.
  15. Install the plastic trims.
  16. Connect the power cord.
    If equipped with the optional LAN, also connect the LAN cord to an outlet.
    Figure 15. * = optional LAN