Reduce the fan speed

By default, the fan speed is set to the maximum speed. Reducing fan speed reduces the noise the fans produce.

If the fan noise is disturbing, you can set the fan speed to less than 100 %.

Note: Reducing the fan speed decreases the rate of air flow inside the pod. Adjusting the fan speed to under 80 % when occupied is not recommended. It is at your own risk to set the fan speed to under 80 % (when occupied).
  1. Disconnect the power cord.
  2. Detach the light from the front ceiling (2Q Huddle and 2Q Lounge) or back ceiling (2Q Standard).
  3. Disconnect the light cord from the LED 1 connector of the control unit. Set the light aside.
  4. The settings in the following step are for software version 2.2 of the control unit. To check the software version of the control unit, scan the QR code on the side of the control unit.
    Note: Older pods might not have the QR code on the control unit.
  5. Use a flat-head screwdriver to turn the arrow of the SETUP switch at the control unit to the desired position.
    The default position is 0.
    Note: The light switches off after 8 minutes of no activity in each of the settings.
    Note: Reducing the fan speed decreases the rate of air flow inside the pod. Adjusting the fan speed to under 80 % when occupied is not recommended. It is at your own risk to set the fan speed to under 80 % (when occupied).
    Table 1. Version 2.2
    Setting Fan speed (pod occupied) Fan speed (pod unoccupied) Ceiling light
    0 100 % 25 % 90 %
    1 80 % 25 % 90 %
    2 100 % 75 % 90 %
    3 80 % 25 % 100 %
    4 100 % 25 % 80 %
    5 80 % 25 % 80 %
    6 100 % 0 % 90 %
    7 80 % 0 % 90 %
    8 80 % 0 % 100 %
    9 100 % 0 % 100 %
    A 60 % 0 % 90 %
    B 100% 100 % 100 %
    C 50% 25 % 90 %
    D 60 % 25 % 90 %
    E 70 % 25 % 90 %
    F 100 % 25 % 100 %
  6. Connect the light cord to the LED 1 connector of the control unit.
  7. Reinstall the light.
    Note: Make sure that the cords are not damaged or pinched during the installation.
    Note: Make sure that the light and the motion detector are level with each other. Use the ceiling felt center line as the midpoint reference.
  8. Connect the power cord.