Install the roof module

Attention:
Make sure that the roof is pulled firmly onto the frame and the frame gasket leg is between the roof and the frame.

  1. Note:
    Insert the screws only about halfway into the holes on the top part of each frame. Do not push them all the way through.
    Note:
    Make sure that you insert the screws into the innermost holes on the glass wall and the second innermost holes on the door frame.

  2. Note:
    Make sure that the roof module is oriented correctly. When looking inside the pod from the door side, the openings for ventilation must be located on the right side of the roof module.
    Note:
    Make sure that the fan cables or the roof module seal do not get pinned between the roof module and pod frame.
    Note:
    Align the slots on the roof module with the pre-inserted screws on the door frame and glass wall.
    • Before tightening the screws, pull down firmly on the roof module to make sure that it is seated properly.
    • Tighten the screws on the door frame first.
    Note:
    Inspect the roof module from the top to make sure that the frame gasket has not come loose during the installation.