Straighten the pod

  1. Push the pod from the left-hand wall and measure the straightness of the strike plate-side glass frame with a spirit level. Adjust if needed and tighten the bolts of the strike plate-side glass frame.
    Note: Press the acoustic panel aside to reach the bolt holes. Make sure that you return the acoustic panel to its original position.
    Note: Make sure that you tighten also the hinge-side screws.
  2. Measure the straightness from the righ-hand with a spirit level. Adjust if needed and tighten the bolts at the joints between the walls and the roof (8 pcs) and at the joints between the walls and the floor (8 pcs). Tighten the bolts between the walls and the glass frames (8 pcs).
    Note: Make sure that you hold the pod in the straight position until all the loose bolts have been tightened.
  3. Hold the pod in the straight position and tighten the screws at the back of the roof and side frame (2 pcs).
    Note: Make sure that you hold the pod in the straight position until all the loose bolts have been tightened.
    Note: Press the acoustic panel aside to reach the bolt holes. Make sure that you return the acoustic panel to its original position.
  4. Tighten the nylon screws (2 pcs each side) on the sides of the back of the pod with a flat-head screwdriver.
    When tightening the nylon screws, lightly push the glasses from the outside to make sure they settle closer to the inner edge of the frame groove.
    Note: The glass adjustment screws are only for stiffening the glass structure. Tighten the screws until you feel resistance, then loosen half a turn. Do not overtighten.