Replace the roof module

  1. Assemble the roof lifting support.
  2. Remove the pins and open the latches at the roof and wall junctions.
    Note: If the power cord has been installed to the roof, disconnect the main power cord from the internal power cord. Make sure the cords are neatly out of the way before lifting the roof.
  3. Use the roof lifting support to lift the roof off the walls.
    Note: Make sure that the guide pins (2 pcs each) at the top of the walls stay in place.
  4. Set the old roof aside and place the new roof onto the lifting support.
  5. Lift the new roof onto the walls with the lifting support.
    Note: Make sure that the new roof is the right way around. The arrow on the front side of the roof should be on the same side as the arrow on the front of the floor.
  6. Close the latches and install the pins at the roof and wall junctions.
    Note: If the power cord was installed to the roof, make sure to reconnect the main power cord to the internal power cord.