Install the power cord from the roof

If installing the power cord from the roof, follow these instructions.
  1. Unscrew the 4x20 screw (1 pcs) and remove the cover plate at the foot of the right side wall. Set the screw and cover plate aside.
  2. From inside the pod, feed the power cord and the DC extension cord into the electric pipe in the ceiling and down to the opening in the floor.
    Note: Make sure that you feed the female end of the DC extension cord down to the floor module.
    Tip: Tape the ends of the power cord and DC extension cord together with electrical tape to make the installation easier.
  3. At the opening, feed the power cord and DC extension cord into the electric pipe and through the opening in the center joint.