Install the glass wall

Warning: Heavy object, risk of injury! Lift carefully. Support the glass wall until securely fastened.
  1. Install the guide pins (4 pcs) to the mounting holes of the wall module.
    Note: Make sure that the flat side of the guide pin goes into the mounting hole.
  2. Lift the glass wall as close to the pod as possible. Use the suction cup.
    Note: Make sure that the glass wall faces the right side up according to the sticker.
  3. Kneel on the floor and lift the glass wall approx. 10 mm (½ in) to fit it into place.
    Warning: Heavy object, risk of injury! Lifting requires 2 people.
    Warning: Do not crush your fingers between the glass wall and the wall module or floor.
    Warning: Support the glass wall until securely fastened.
    Warning: Make sure that the glass wall cannot tip over during installation.
  4. Support the wall and install it with M8x35 bolts (6 pcs) and M8 washers (6 pcs). Tighten the bolts by hand.
  5. Tighten the bolts on the modules with a wrench.
    Note: Make sure that you tighten the bolts in the correct order.
  6. Install the M8x35 bolts (4 pcs) and M8 washers (4 pcs) to the roof and floor modules.
    Note: Press the acoustic panel aside to reach the bolt holes. Make sure that you return the acoustic panel to its original position.