Adjust the door height

Make sure that the door is vertically aligned correctly. If the door is not in the middle of the frame, adjust it.
  1. Remove the caps from both hinges.
  2. Open the door and loosen the set screws of both hinges.
  3. Close the door.
  4. To raise the door, insert the hex key into the top of the upper hinge and turn clockwise. To lower the door, turn counter-clockwise.
    Note: After the initial installation, the door normally does not have to be lowered, but raised.
  5. Adjust the height setting of the lower hinge accordingly so that the load on both hinges is the same. Turn clockwise to raise and counter-clockwise to lower the setting.
  6. Make sure that the door is aligned correctly.
  7. Test with a flashlight from the inside of the pod.
    If the flashlight shines through the door seams, adjust the door.
  8. Repeat steps 4–6 if needed.
  9. Close the door.
  10. Open the door and tighten the set screws when the adjustment is complete.
    Note: Make sure that both hinges have the same height setting.
  11. Install the caps to both hinges.