Install the power outlet

  1. Place the power outlet onto the fixing plate at the bottom of the table top and turn it clockwise until it locks into place.
  2. Lead the power outlet cord through the opening at the base of the table leg.
  3. Open the metal box lid.
  4. Connect the power outlet cord to the power unit.
    A "click" sound is audible when the connector locks into place.
  5. Close the lid of the metal box.
    Note: Make sure that the cords come out of the notch of the metal box and are not pinched or damaged.
  6. Feed the power outlet cord into the groove in the table leg.
    If the table is equipped with a wireless charger, also pull the excess cord of the wireless charger into the groove in the table leg.
  7. If not installing the optional wireless charger, continue to step 11. Connect the USB cord of the wireless charger to the USB connector of the 5V unit.
    Note: If both the booking system bracket and wireless charger are installed, connect the wireless charger cord to the USB connector on the power outlet.
  8. Place the 5V unit in the floor module through the opening in the floor cover board.
  9. Install the base of the table leg with M6x20 countersunk screws (6 pcs) and 5x50 screws (4 pcs).
    Note: Make sure that the cords are not pinched or damaged during the installation.
  10. Install the small cover board with 4x20 screws (2 pcs).
    Note: Make sure that the cords are not pinched or damaged.
  11. Press the rubber strip onto the table leg.